Laagen-Desibel.Com
Tlf 91534656
post@laagen-desibel.com
USER’S MANUAL
7”TFT LCD UNDERWATER
MONITOR SYSTEM

Before
operating the unit, please read this manual thoroughly
And retain it
for future reference
Ⅰ Important
Safety Precautions
Thank
you for purchasing our 7” TFT LCD Underwater Monitor System, this system can
help you know the situation underwater, and this system is usually
Used
for fishing, diving and swimming.
l Disconnect the AC/DC
Adaptor or Rechargeable Battery from the Monitor when the system is not in use.
l Make sure only use the
AC/DC Adaptor and Rechargeable
l To avoid overheating, keep
the camera, monitor and AC/DC Adaptor or Rechargeable Battery away from heat
sources, such as radiators, heat registers, stoves, or other appliances which
produce heat.
l The camera must not be located to look directly to the sun or other bright light source as this will not only result in a poor image, but will eventually damage the electronics of the camera.
l Areas with a high degree of contrast in the light levels require careful. Positioning of the camera to obtain the best image.
l The best viewing angles is achieved by placing the camera in a position where it is looking down on the subject
l Additional lighting may be required if water quality is poor, or in low light conditions.
l Always wash the camera in warm water and soap after use, to remove salt and other corrosive agents.
l Always use appropriate water safety precautions when operating the underwater camera, and ensure appropriate level of supervision of children when near water.
l NOTE: The polarity of the battery can not be connected wrongly!
1
Ⅷ
Features
1. The whole set packed in a
carrying case.
2. 21 white LED lights design,
providing a wide underwater vision range (3-5m)
3. Equipped with a cable
roller, easy for you using
4. With a Charger Box, to
protect the battery from being over-charged
5. With a Car/Boat Cigarette
Power Adaptor, available for you to charge the battery on boat
Ⅸ Technical
Specifications
Monitor:
|
Picture
Tube |
7” TFT LCD |
|
Video System |
PAL and NTSC |
|
Resolution |
480(H)×234(V) |
|
Video
Input |
Two
Channels |
|
Audio
Input |
One
Channel |
|
Operating
Temperature |
-15℃
to 50℃ |
|
Power
Supply |
DC 12V±10% ≤800mA |
|
Power Consumption |
≤9.6W |
|
Case Size |
390×295×135mm |
Camera:
|
Image Sensor |
1/3”(PAL)
/ 1/4”(NTSC) Color COMS |
|
Video System |
PAL/NTSC Stand
TV system |
|
Picture Pixels |
300000 |
|
Lens |
6mm (PAL)
/ 4.5mm(NTSC) |
|
Minimum Illumination |
1.5 Lux |
|
Visible
Angel |
65 Degree |
|
Compensation |
with 21
White LED Lights |
|
Power Supply |
DC12V |
|
Current Consumption |
≤150mA |
6
Ⅵ Charging When Using

Ⅶ Trouble
Shooting
If
the system does not perform properly, check the following points
|
UNIT |
PROBLEM |
REMEDY |
|
MONITOR |
Too
dark or too bright |
Re-adjust the Color, Contrast or Brightness
of the Monitor in Menu |
|
No
power |
Check the connection of
the power source Check
if the |
|
|
Poor
picture |
Clean
the camera head glass, re-adjust the Color, Contrast or Brightness of the
Monitor |
|
|
Shrinking
picture |
Check
the connection of the power source Check
if the battery is in low voltage |
|
|
No
picture |
Check
the cable for any loose connection |
|
|
CAMERA |
Picture
flickering or
over exposed |
Make
sure the camera is not facing any direct light or sunlight |
5
Ⅱ Monitor Controls
(picture 1)
1. Monitor

1.
AV Input
Socket
2.
Earphone
Socket
3.
AV1/AV2
(select input signal)
4.
Adjustment
Button (﹣)
(adjust volume, contrast, color, brightness in menu)
5.
Adjustment Button
(﹢)
(adjust volume, contrast, color, brightness in menu)
6.
Menu Button
7.
Selcet Button
(Up)
8.
Selcet Button
(Down)
9.
Power Switch
10. Remote Control Reception
11. Power Indicator
2
2. Remote Controller (picture 2)

1. Mute 6. User-Defined Button
2. Selcet Button (Up)
7. AV1/AV2 Select Button
3. Adjustment Button (﹣)
8. Selcet Button (Down)
4. Menu 9. Adjustment Button (﹢)
5. System 10. Power
3.Camera (picture 3)

1. 18 M Cable
2. Underwater Camera with 21
White LED Lights
3. Stainless Steel Ballast
4. 4-P MIC Plug
3
Ⅲ System
Connecting (picture 4)

!NOTE: The polarity of the battery can not be
connected wrongly!
*The Car/Boat Cigarette Power Adaptor can replace the
Ⅳ Charge
Connecting (picture 5)
!NOTE: The polarity of the battery can not be
connected wrongly!
*The Car/Boat
Cigarette Power Adaptor can replace the AC/DC Adaptor to charge the
Ⅴ Packing
List
1.
7” TFT LCD Monitor
7. Charger box
2.
Underwater Camera 8. Remote Controller
3.
Stainless Steel Ballast
9. Connection Cables
4.
12V AC/DC Adaptor 10. Cable Roller
5.
Rechargeable
6.
Car/Boat Cigarette Power Adaptor 12. User’s Manual
4